Learning of the correlation:
- Change the position of the movement to one extreme.
- Enter in "cal item 1" the SERVO item
- Set "cal auto" to 0
- Set in "cal item 1" the START item
- Set "learn enable" to 1
- Slowly move to the other extreme. Watch out! Software limits are
inactive!
- Set "learn enable" back to 0
- Change "cal item 1" to the SERVO item
- Set "cal auto" to 1
| movement |
Dia. Rot |
Gantry |
X1 |
X2 |
Y1 |
Y2 |
| Servo Item |
349 |
348 |
350 |
351 |
352 |
353 |
| Start Item |
275 |
270 |
280 |
285 |
290 |
295 |
Check calibration of readings afterwards.
Jan Kok
2010-03-05
